Get Free Quote

Custom-built

Non-standard geometry, finish or loading — built from your drawing, your site survey or your specification.

Specification parameters

1. What Can Be Made to Drawing

Roll-formed profilesW-beam and thrie-beam rail profiles from 480 – 482 mm and 750 mm wide coil, holes punched before forming
Cut, punched and bent partsPlates, brackets and base plates cut from sheet or plate and formed on a press brake
Welded assembliesParts too thick to bend made as welded assemblies
Tubular poles and columnsConical, octagonal or round shafts with a welded longitudinal seam

2. Process Envelope (Typical Industry Figures)

Roll forming thickness2.0 – 4.0 mm (some lines 2.5 – 4.2 mm); cut-length tolerance approx. ± 2 mm
Laser cutting, carbon steelUp to approx. 20 – 25 mm on fibre-laser beds of 3000 × 1500 mm to 4000 × 2000 mm
Press brake bendingBend length approx. 3.1 – 4 m on common machines; bending thickness often limited to approx. 10 mm
PunchingHydraulic or pneumatic punching of hole patterns before roll forming; servo-fed press punching on 3-wave lines

3. Hot-Dip Galvanizing Envelope

Kettle lengthChinese guardrail / pole lines: 6.5 m kettles for guardrail posts and sign poles; 13 – 13.5 m for long poles and rail. North American average approx. 12 m (40 ft), many 15 – 18 m
Oversize itemsProgressive (double) dipping possible when more than half of the item fits the kettle
Small partsParts under approx. 760 mm (30 in) galvanized in baskets and centrifuged
ASTM A123 alternativeMinimum average 45 – 100 µm by material category and measured steel thickness
Repaired areas (ISO 1461)Coating at least 30 µm above the local thickness requirement

4. Powder Coating & Duplex Systems

Surface preparationGalvanized surfaces prepared for powder coating to ASTM D7803; for liquid paint to ASTM D6386
Outgassing controlASTM D7803 adds a thermal pre-treatment after surface preparation to prevent outgassing during curing
Duplex service lifeGalvanizing plus paint or powder lasts 1.5 – 2.3 times the sum of either system alone (AGA duplex multiplier)
ColourRAL colour range over galvanizing

5. Fabrication Standards

EN 1090-2 execution classesEXC1 – EXC4, chosen by the designer from consequence, service and production categories
Welding quality (ISO 3834)EXC1: Part 4 elementary; EXC2: Part 3 standard; EXC3 / EXC4: Part 2 comprehensive
Welding coordinationResponsible welding coordinator required for EXC2 – EXC4
Procedure and welder qualificationISO 15614-1 procedure qualification and EN ISO 9606-1 welder qualification from EXC2 up
Weld quality levels (ISO 5817)EXC1: D; EXC2: C; EXC3: B; EXC4: B+