
Custom Steel Fabrication
Also known as: custom guardrail
Custom steel fabrication to your drawing, sample or written specification. Roll forming, pressing, punching and welding, galvanised or powder coated.
- Choose this when
- A drawing or site survey that no catalogue item matches.
- Choose another when
- A standard range item, which is cheaper and already proven.
- Forming
- Roll forming on own lines; press brake bending; pressing
- Cutting & holes
- Shearing, sawing, punching to drawing
- SampleSample available on request, freight at cost
- PaymentT/T, L/C at sight — terms confirmed on the quotation
- ShippingFOB / CIF from Qingdao or Tianjin
- Lead time5–20 days after drawing approval
Where it is used
Non-standard parts built to drawing, sample or written specification.
Specification parameters
Processes
| Forming | Roll forming on own lines; press brake bending; pressing |
|---|---|
| Cutting & holes | Shearing, sawing, punching to drawing |
| Welding | MIG/MAG and submerged arc welding (typical) |
| Input | Drawing, physical sample or written specification |
Capability envelope
| Steel grades | Q235B, Q355B, S235JR, S355JR, A36 |
|---|---|
| Sheet / plate thickness | approx. 2 - 12 mm (typical) |
| Max part length | approx. 12 m, set by the galvanising bath (typical) |
| Tooling | Quoted separately for new profiles and press dies |
Finishes
| Hot-dip galvanising | Batch dip, zinc mass to project specification |
|---|---|
| Powder coating | Over galvanising (duplex) or on bare steel |
| Inspection | First-article check against drawing before the run |